Home About Us Products Application Enquiry Contact Us
 
Crushing and Material Handling System

Vibro Feeder  

Vibratory feeder is used to transfer the various size materials or granular materials from hopper to receiving device uniformly, continuously and periodically in the production flow and to feed materials into the Belt Conveyor or Crusher continuously and uniformly. The vibrating feeder is widely used to match the crushing and sieving equipments in many industries including metallurgy, coal mine, mineral dressing, building material, chemical, grinding, etc.

Belt Conveyor System

Transfer the material from ground level to Top Hooper, This system operationally very easy, less maintanence, consume less power but occupy the big length area, specially suitable for granual particle liks, Crush Coal, Sawdust, Husk ect.

 
Fuel Crusher

Single Rotor, Swing Knittle (Triangular Hammer) Stephens Adamson design for sizing of Coal / Lignite for less than 8mm particle. All hammer and breaking plate to be hardened by hard facing Rod ( Nickle – Crome ) which gives better hammer life.

 
Bucket Elevator

Bucket Elevator take a material from bottom to vertically top on the Hooper, The system occupy very less space and easy to operation.

 

Bucket Elevator design according to partical size and density, for very lighter material like Sawdust, continuous type Bucket Elevator suitable for the same, where heavy material like, Coal / Lignite use a Centrifugal type discharge Bucket Elevator.

 
Our Products
 
Direct Fired Hot Air Generator
Indirect Fired Hot Air Generator
Steam Boiler
Thermic Fluid Heater
Crushing and Material Handling System
More Products